Mike: Hope you can help. I am in the process of rebuilding the front end of my ’57 Chevy car. If I use 2″ lowering springs, can I use the same front shocks or do I need to get something else? Would it be better to install the 2″ lowering spindles instead of the springs? […]

Mike, I need to lower the front of my car approximately 1 to 1 1/2inches. I understood from your " Question of The Week "answer, that you would cut an Inch off the spring to lower it an Inch but people are telling me that I am reading that wrong and that I would have […]

Q -Mike, I have a Riviera that I want lowered about 2 Inches in the rear. You don’t make lowered springs for this car, something about not enough demand. So what I want to do is cut the coils. Is this alright? Frank from Seattle A -Frank, in a lot of cases it is fine […]

Mike, I cannot believe I finally found a spring expert! I have read all your tech articles and thank you very much for sharing your knowledge. Now for my question – Can you take an existing spring, stretch it and then shorten it to get a stiffer spring rate while keeping the car at the […]